Feet&Roll Express Electronic Anti-Hardness File

INSTRUCTIONS FOR USE

1. Wash and dry your feet thoroughly
2. Position the head according to the thickness of the hardness to be removed:Light hardness and final finish: fine grain Medium hardness: medium grain Severe hardness: coarse grainYou can also combine the different heads during the filing process: Start with the coarse or medium grain head and finish with the fine grain head to obtain a fine and smooth skin.
3. Press the power button and the head will start spinning at fast speed (red light). If you want to switch to extra fast speed (green light) press the button again.
4. Perform rotating movements on the calluses, without exerting too much pressure, you will see how the dead skin is eliminated. It is advisable to keep changing the area to obtain a homogeneous result.
5. Turn off the electronic file by pressing the power button. Check the result, you can run the file again with the fine-grained head until the desired result is obtained.
6. After each use, turn off the file and clean it according to the instructions in the "Maintenance and cleaning" section of the faq's. Important: do not immerse or soak the main body of the electronic file in water. For hygienic reasons, we recommend that you do not exchange the electronic file with other users.

WARNINGS

Do not use the electronic anti-hardness file:

• On an area of the body other than the feet
• On the skin if it is wounded or infected
• On blisters, warts, risk areas (varicose veins, moles, birthmarks) or if you have any skin condition (eczema, inflammations).
• If you suffer from diabetes or poor blood circulation
• If plugged into the battery charging cable
• Keep out of reach of children

How to change the head

With the electronic file turned off, remove the head by pulling it outwards. To place it, fit the head as shown in the picture, you will notice a "click" that indicates that it has been correctly placed.

Cleaning and maintenance

Always clean with the file switched off. To open, turn the socket disk counterclockwise. Use the brush to clean the inside. Do not immerse or use water or abrasive or corrosive products to clean it. To clean the sponge, remove the socket disk from the head and remove the hole piece. The sponge and the part with holes can be washed with water, but must be dry before reattaching. Replace the socket disk by turning it clockwise, making sure it is in the closed position.

Charging system

It can be charged by connecting the USB cable to a 5V 1A transformer (not included) or to a personal computer. When the indicator is red, the battery needs to be charged. When the indicator changes to green light, it is fully charged. Be sure to recharge after each use to maintain optimum performance of the lithium battery. The full charging time is 2h, once charged it is recommended to disconnect it from the power supply.